Follow us on Twitter and win Autohex II Scan Tool for Kia and Hyundai (worth 945.00 USD)

B1378 Driver Side Airbag - Resistance too High H

AutoHex Online Help: Hyundai MATRIX(FC) 2003
CIRCUIT INSPECTION

DTC

B1377 DSAB open circuit (R = 8)

B1378 DSAB resistance too high (R = 4.31 ?)

B1379 DSAB resistance too low (R = 0.83 ?)

B1382 PSAB resistance too high (R = 4.31 ?)

B1383 PSAB resistance too low (R = 0.83 ?)

B1386 PSAB open circuit (R = 8)

CIRCUIT DESCRIPTION

The SAB squib circuit consists of the SRSCM and SAB. It causes the airbag to deploy when the airbag deployment conditions are satisfied. The above DTCs are recorded when the SAB circuit is open or the SAB resistance too high or low is detected in the SAB squib circuit.

DTC Detecting Condition

Trouble Area

Too high or low resistance between SAB high (+) wiring harness and SAB low (-) wiring harness of squib.

SAB malfunction

SRSCM malfunction

SAB squib

SRSCM

Wire harness

WIRING DIAGRAM
INSPECTION PROCEDURE

Preparation

Disconnect the negative (-) terminal cable from the battery, and wait at least 30 seconds.

Remove the DAB module.

Disconnect the connectors of the PAB, left and right side airbags, belt pretensioners and satellite sensors.

Disconnect the SRSCM connector.

caution

Place the DAB with the front surface facing upward.

Check the DAB resistance.

[PREPARATION]

Release the airbag activation prevention mechanism on the SRSCM side of the airbag squib side. Connect the dummy (0957A-38200) and dummy adapter (0957A-38300) to the SAB connector of the SRSCM connector side.

note

Before checking the resistance, you have to insert the shorting bar insert plastic that is attached to the diagnosis checker into the SRSCM connector.

[CHECK]

Measure the resistance between the SAB high (+) and low SAB low(-).

Check the SAB squib.

[PREPARATION]

Turn the ignition switch to LOCK.

Disconnect the negative (-) terminal cable from the battery, and wait for 30 seconds.

Connect the SAB connector.

Connect the negative (-) terminal cable to the battery, and wait for 30 seconds.

[CHECK]

Turn the ignition switch to ON, and wait for at least 30 seconds.

Clear the malfunction code stored in the memory with Hi-Scan Pro.

Turn the ignition switch to LOCK, and wait for 30 seconds.

Turn the ignition switch ON, and wait for 30 seconds.

Using the Hi-Scan Pro, check the DTC.

There is no DTC.

[HINT]

Codes other than these may be output at this time, but they are not relevant to this procedure.