Follow us on Twitter and win Autohex II Scan Tool for Kia and Hyundai (worth 945.00 USD)
P2191 System too Lean at Higher Load (Multiple) (Bank 1)
AutoHex Online Help: Hyundai i10(PA) 2011
General Description
In order to provide the best possible combination of drivability, fuel economy and emission control, the ECM uses a closed loop air/fuel metering system. The ECM monitors the HO2S signal voltage and adjusts fuel delivery based it in closed loop fuel control. Changes in fuel delivery will be indicated by the long-term and the short-term fuel trim values. The ideal fuel trim value is around 0%. The ECM will add fuel when the HO2S signal is indicating a lean condition. Additional fuel is indicated by fuel trim values that are above 0%. The ECM will reduce fuel when the HO2S signal is indicating a rich condition. Reduction in fuel is indicated by fuel trim values that are below 0%. The DTC relevant to fuel trim will be set when the amount reaches excessive levels because of a lean or rich condition.
DTC Description
ECM sets DTC P2191 if ECM monitors and detects fuel adaptation value is higher than specifications while vehicle is not in idle condition.
DTC Detecting Condition
Item | Detecting Condition | Possible Cause |
DTC Strategy | Check the revised air-fuel-ratio
| Air leakage Improper fuel pressure PCV valve stuck Clogging of injector |
Enable Conditions | Coolant temperature > 80.3?
Intake air temperature < 80.3?
Throttle angle < 57%
Lambda feed back control condition - active
Purge valve control duty = 0%
No MAP sensor error
No purge valve error
Engine speed 1560 ~3200 rpm
Air mass 20~55 kg/h
|
Threshold Value | Fuel adaptive value of Multiplicative fuel adaption range > 1.24
|
Diagnostic Time | 10 sec.
|
MIL ON Condition | 3 driving cycle
|