Follow us on Twitter and win Autohex II Scan Tool for Kia and Hyundai (worth 945.00 USD)

C1314 Rear Left Sensor RF Channel Failure

AutoHex Online Help: Hyundai i20(PB) 2011
Component Location
General Description

?Wheel Electronic (WE) sensor unit?- TPMS sensor

Each vehicle wheel is fitted with a Wheel Electronic (WE) sensor unit attached to the valve on the inside of the wheel. The WE unit is powered with a self-contained battery utilizing a high temperature rated CR (Manganese Dioxide Lithium) chemistry. The operating voltage range for the WE module is 1.8Vdc to 3.6Vdc, and the operating temperature range is -40? ~120?. The WE measures tire pressure, temperature, and acceleration periodically. The pressure, temperature, and acceleration information is converted to digital form within the MCU inside the WE sensor.

The WE sensor is equipped with a Radio Frequency (RF) transmitter circuit which is used to periodically broadcast information from inside the tire. All WE sensor units operate on the same RF channel frequency, and each broadcast message includes pressure and temperature data, a unique ID code, operating state data, status information, and digital error-detection data.

The pressure measured by the WE sensor is an absolute pressure value. The pressure measurement range is 100kPa to 450kPa. The acceleration data is used within the WE sensor to determine whether the vehicle is moving or stationary. The acceleration status is the decision maker within the WE module that determines if the tire is moving or stationary. This measurement is used within the WE module to enable different operating modes depending on the status of the acceleration value. Over the fully specified operating temperature range, if the acceleration measurement is greater than or equal to 5G, the WE module assumes the tire is moving.

The basic function of the WE Sensor is to transmit frame every minute when WE is in mode MD(mode driving) mode. The WE sensor enters mode MP(Mode Parking) where it transmits RF messages once every 13 hours if acceleration is lower than 5g for 15 mimutes. When the WE sensor is in mode MFB(Mode First Burst : mode for Auto Location and Auto Learning), it transmits RF message once every 15 seconds.



DTC Description

This DTC indicates that the receiver did not receive any message from the Rear Left sensor for 9 minutes during driving. The most likely cause is RF transmitter fault in WE sensor.

DTC Detecting Condition

Item

Detecting Condition

Possible Cause

DTC Strategy

Check RF message from RL sensor

RL WE sensor in storage state.

Shielding in RL WE sensor.

Enable Conditions

Vehicle Speed is above 20km/h.

Threshold value

No RF message received from RL sensor since driving for 540s

Mil On conditon

Active DTC is set