This data input goes through CAN communication line and TCM is able to request for "Shift Inhibite and torque reduction" on the basis of this signal.
TCM set this code If not match Engine torque signal with TCM torque signal.(MIL ON : 2 driving Cycle)
Item
Detecting Condition
Possible Cause
DTC Strategy
Check signal
ECM
Enable Conditions
IG s/w "ON"
CAN BUS : normal
DME CAN : normal
Battery voltage > 9V
Threshold Value
Torque signal abnormal in CAN message
Diagnostic Time
0.5second
Fail Safe
Maintain present gear position at fault detecting.
Fixed at 3rd gear after stop
Maximum line pressure control (D : 14kg/?, R : 20kg/?)
No control Torque convertor clutch
No learning control
(Priority : 3)
The function with the higher priority will aiways take precedence. However, a low-priority is not overruled by a higher priority function.
Functions from different priority categories can also run in parallel. It is important to note which function will take precedence in this case.
In such an event it is possible for a substitute function with low priority not be carried out if a second, higher-priority function is present. This has been taken into account when compiling the priority list and is international.
The mechanical emergency run function must always have the highest priority, since from the electrical standpoint it is the only safe condition.