Component Location
General Description
When the TP sensor’s signal indicates closed throttle position and the engine is idling, the PCM adjusts the idle speed control actuator so that the engine runs at the correct idling speed, regardless of coolant temperature, load and etc. When the additional load applied in the engine, the air flow through the idle speed control actuator is increased momentarily to raise the idling speed.
DTC Description
The PCM monitors engine speed deviation from the target idle engine speed when the vehicle is stopped and the throttle valve opening is stable. The PCM sets DTC P0507 if the difference to the target idle engine speed is higher than the predetermined threshold.
DTC Detecting Condition
Item | Detecting Condition | Possible Cause |
DTC Strategy | Monitoring deviation between target idle speed and actual engine speed
| A stuck or binding throttle body Air leakage Poor connection or damaged harness Faulty ETC |
Enable Conditions | Coolant temp. > 165?
Time elapsed after ( pedal value = 0% and vehicle speed = 0mph)
11< Battery voltage <16
No relevant failure
|
Threshold Value | Current RPM >Target RPM +200rpm Engine speed too high
|
Diagnostic Time | 17 sec.
|
Mil On Condition | 2 driving cycle
|