General Description
In order to provide the best possible combination of drivability, fuel economy and emission control, the ECM uses a closed loop air/fuel metering system. The ECM monitors the HO2S signal voltage and adjusts fuel delivery based it in closed loop fuel control. Changes in fuel delivery will be indicated by the long-term and the short-term fuel trim values. The ideal fuel trim value is around 0%. The ECM will add fuel when the HO2S signal is indicating a lean condition.
Additional fuel is indicated by fuel trim values that are above 0%. The ECM will reduce fuel when the HO2S signal is indicating a rich condition. Reduction in fuel is indicated by fuel trim values that are below 0%. The DTC relevant to fuel trim will be set when the amount reaches excessive levels because of a lean or rich condition.
DTC Description
If the revised air-fuel-ratio at idle exceeds the certain period, ECM recognizes it as a fault and sends P2188.
DTC Detecting Condition
Item | Detecting Condition | Possible Cause |
DTC Strategy | Check the revised air-fuel-ratio at idle
| Blocking of intake system Fuel leakage in injector Improper fuel pressure |
Enable Conditions | Coolant temperature > 80.3?
Intake air temperature < 80.3?
Throttle angle < 60%
Lambda feed back control condition - active
Purge valve control duty = 0%
No MAP sensor error
No purge valve error
No WTS error
Engine speed = 920rpm
Air mass = 24kg/h
|
Threshold Value | Air mass correction value of additive fuel adaption range < -2.9 kg/h
|
Diagnostic Time | 10 sec
|
MIL ON Condition | 3 Driving Cycles
|